Bianco BIA-LRS32-6CU

Stock Replacement Parts

We carry a huge range of solar hot water circulating pumps. Solar Hot Water Repairs will repair or replace any brand of solar hot water system or hot water system. We are mainly based on the Sunshine Coast and can easily fix system in a wide range of areas.

  • Bianco BIA-LRS32-6CU

    Bianco BIA-LRS32-6CU

    Bianco BIA-LRS32-6CU 3 speed hot water circulating pump, was used for short period of time as a solar hot water circulating pump in early manufacture periods of solar hot water. It was generally installed outside with older style systems. Some had poor sensor port locations or non at all.  Apricus used this pump for a small period of time along with a few other manufacturers. Over the years we have been called out to plumbing repairs and service requests to find the Bianco BIA-LRS32-6CU circulating pump that had been installed into other systems like Hills Solar, Chromagen, AAE or Edson. The most common thing people notice when these pumps fail is that the power circuit of the pump installed will trip the circuit breaker. Sometimes this can take a while to locate and realise that the circulating pump is the problem and not the actual controller. We always replace this pump with the Grundfos 15 20 Cil solar hot water circulating pump and where possible install a pump station cover. 

    The original Bianco BIA-LRS32-6CU 3 Speed Circulating Pump

    The pump is characterised by:

    • Materials of construction suitable for potable water
    • 3 speed operation for lower power consumption
    • Flows to 65 litres/minute, heads to 6m

    Pump Performance: Max. flow speeds 1, 2, 3: 20 l/m, 42 l/m, 65 l/m

    Max heads speeds 1, 2, 3: 3m, 5m, 6m

    Liquid: Max. operating water temperature: 80º C; Temperature: Class 110

    Materials: Pump body: Bronze, DR, Back Plate and Rotor; Can: Stainless Steel; Impeller: PPO

    Installation: Maximum ambient temperature: 40º C; Maximum operating pressure: 10 bar

    Port Spacing: 150m; Pipe connections suction/discharge ; 1-1/4" BSP M

    Optional Union Set: 1-1/4" BSP F/3/4" BSP F

    Electrical data: Rated voltage: 240V, Mains frequency: 50 Hz

    Current Max: 0.4 amps Capacitor: 3uF, Power consumption speeds 1, 2, 3: 46W, 67W, 100W

    Motor Duty: Continuous Motor type: Canned rotor; Motor protection: In-built thermal overload

    Ingress protection: IP 42 Insulation class: F; Power cable length: 1.2m; Net weight: 4.0 kg

     

    Billing information

  •